Before Installation; Installation Space; Installation Procedures - Hitachi PC-ARFP1E Installations- Und Betriebshandbuch

INSTALLATION WORK

2.2 BEFORE INSTALLATION

Check the contents and the number of the accessories in the packing.
Remote control switch for

2.3 INSTALLATION SPACE

In case of installing the controllers in vertical line, keep a
distance more than 50mm between the controllers vertically.
If the distance is insufficient, the controller can not be taken out.

2.4 INSTALLATION PROCEDURES

1 Insert the edge of the slotted screwdriver into the groove at
the bottom of the holding bracket, push and turn the slotted
screw driver and then remove the remote control switch from
the holding bracket.
Groove part Groove Part
Figure seen from bottom side
2 Attach the remote control switch to the holding bracket and
connect the cable as follows:
- In Case of Exposing Remote Control Cable
Fix the holding bracket onto the wall with screws
(accessory).
2 PMML0404A rev.1.1 - 06/2022
Meeting Room
A/C FLTR
MODE SPEED LOUV. TEMP
COOL
HIGH
Motion Sensor is activated
LOUV. ADJ
OK
2 screws M4x16L for fixing the
operation control holding bracket onto the wall
Approx.
6mm
Slotted
Screw driver
Groove for attaching
controller
Attach the stopper (plastic band) to the cable at the
inside of the draw-out hole.
Cable
Band stopper
(Field-supplied)
Rear
cover
When Using Switch Box
-
a. Prepare field-supplied Implanted Switch Box
(JIS Box). (JIS C 8336-1988)
The following 5 types are available.
1. Switch Box for 1 Switch (Without Cover)
2. Switch Box for 2 Switches (Without Cover)
3. Switch Box for 1 Switch (With Cover)
4. Switch Box for 2 Switches (With Cover)
5. Outlet Box (With Cover)
1 Operation Manual
> 50mm
Draw-out hole
Lead the cable with its sheath
Lead the cable with its
peeled through the groove.
sheath peeled through
the groove.
Peel the insulation at the
Peel the insulation at
end of the cable and clamp
the end of the cable and
clamp the M3 solderless
the M3 solderless terminals
terminals (field-supplied).
(field-supplied).