Installation Procedure - Hitachi ECO COMPACT PC-ARCHE Bedienungsanleitung

heat sources, and where it is not affected by outdoor air currents from opening and
closing doors.
Prior to the installation work, ensure that surface is flat and sufficiently strong and
then fix the unit securely.
Check the contents and the quantity of the accessories in the packing.
✓ (ii) A - Remote control switch for operation control
✓ B - 2 M4x16 screws for fixation of the holding bracket onto the wall
✓ C -1 Instruction Manual
✓ D - 1 Connecting wire (300 mm length)
When arranging the wired remote controller and other controllers vertically, place
them at least 2 inches (50mm) apart. (iii).

2.1 Installation Procedure

1. Insert the edge of the slotted screwdriver into the groove at the bottom of the
holding bracket, push and turn the slotted screwdriver to separate and remove
the controller from the holding bracket.
✓ (iv) A - Groove part
✓ B - Approx. 6mm
✓ C - Slotted screwdriver
✓ D - View from the bottom side
✓ E - Wall mount
✓ F - Tabs for attachment of the controller

NOTE
Do not insert the slotted screwdriver into the tab part beside the groove. The tab may be dam­
aged and the wired remote controller cannot be installed.
2. Attach the controller to the holding bracket and connect the cable as follows:
• In Case of Exposing the Controller Cable
Fix the holding bracket onto the wall with screws (accessory). (v)
Attach the stopper (plastic band) to the cable at the inner side of the draw-out
hole.
✓ (vi) B - Cable
✓ C - Band stopper (Field-supplied)
✓ D - Draw-out hole
✓ E - Plug the connector of the connecting wire into the CN1.
✓ F - Connect wire stuck in the slot.
EN
PMML0650 rev.0 - 03/2023 - 1000014300 2