Symbols And Labels Used In The Manual And On The Dryer - Ingersoll-Rand D600IN-W Bedienerhandbuch

INTRODUCTION
This manual is an integral part of the dryer you bought, and must remain with the machine even if this will be resold.
It is highly recommended that the qualified*personnel for installation maintenance and/or control will fully comply with the contents
of this manual and the prevention and safety rules in force in the country where the system will be used. In this way, not only the
usage of the machine will be rational, but also the service will result cost effective.
In case your dryer will present any kind of problem, please contact your local authorized Ingersoll Rand distributor.
Please note that, when necessary, the use of original spare parts will ensure efficiency and long duration to your dryer.
Due to the continuous technological evolution, Ingersoll Rand reserves the right to modify the specifications contained in this
manual without giving previous notice.

SYMBOLS AND LABELS USED IN THE MANUAL AND ON THE DRYER

or or
Read the Operators manual before attempt to
start up the machine and to perform any service
operation on the dryer.
Pay particular attention to the indications
preceded by these symbols.
Installation,
operations preceded by these symbols must be
performed exclusively by qualified personnel*.
or
Pay particular attention to the risk of moving
parts
Attention:
maintenance
machine, do not forget to disconnect
the
discharge air pressure, and to refer to
the Operators manual
* Qualified personnel must be trained and certified in accordance with local laws and regulations.
WARRANTY
The Company warrants that the equipment manufactured by it and delivered hereunder will be free of defects in material and
workmanship for a period of twelve months from the date of placing the Equipment in operation or eighteen months from the date of
shipment from the factory, whichever shall first occur. The Purchaser shall be obligated to promptly report any failure to conform to
this warranty, in writing to the Company in said period, whereupon the Company shall, at its option, correct such nonconformity, by
suitable repair to such equipment or, furnish a replacement part F.O.B. point of shipment, provided the Purchaser has stored,
installed, maintained and operated such Equipment in accordance with good industry practices and has complied with specific
recommendations of the Company. Accessories or equipment furnished by the Company, but manufactured by others, shall carry
whatever warranty the manufacturers have conveyed to the Company and which can be passed on to the Purchaser. The Company
shall not be liable for any repairs, replacements, or adjustments to the Equipment or any costs of labor performed by the Purchaser or
others without Company's prior written approval.
The effects of corrosion, erosion and normal wear and tear are specifically excluded. Performance warranties are limited to those
specifically stated within the Company's proposal. Unless responsibility for meeting such performance warranties are limited to
specified tests, the Company's obligation shall be to correct in the manner and for the period of time provided above.
THE COMPANY MAKES NO OTHER WARRANTY OR REPRESENTATION OF ANY KIND WHATSOEVER, EXPRESSED OR
IMPLIED, EXCEPT THAT OF TITLE, AND ALL IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, ARE HERBY DISCLAIMED.
Cod. 710.0138.40.01 Rev01 – 01.2013
or or
maintenance, and/or
Condensate drain point.
Before performing
operation on
electric supply, to completely
- Turn main power switch on position 1.
- Wait for 8 hours before starting the dryer.
- EN -
Air
inlet.
or
Pay particular attention to components or systems
under pressure.
Pay particular attention to hot surfaces.
control
Pay particular attention to the risk of electric
shock.
any
this
or or or
Air
outlet.
7 - 170