How Safety Instructions Are Displayed; Product-Specific Safety Instructions; Electrical Hazard - BWT Multi C 1000 Einbau- Und Bedienungsanleitung

1.6

How safety instructions are displayed

In this document safety instructions precede any sequence of actions
that could cause harm to persons or damage to property. All hazard
prevention measures must be followed.
Safety instructions are displayed as follows:
SIGNAL WORD!
Source of hazard (e.g. electric shock)
Type of hazard (e.g. risk of fatal injury)!
►Escape or prevent hazard
►Rescue measure (optional)
Signal word / colour
Indicates the severity of the hazard
Warning symbol Calls attention to the hazard
Source / type of Indicates the type and the source of the
hazard
hazard
Consequences of Explains the consequences of not following
hazard the safety instructions
Hazard prevention
Explains how to avoid the hazard
measure
Signal word Colour Severity of the hazard
High-risk hazard.
Indicates a hazardous situation which, if
DANGER
not avoided, will result in death or serious
injury.
Hazard with a moderate degree of risk.
Indicates a hazardous situation which,
WARNING
if not avoided, could result in death or
serious injury.
Low-risk hazard.
Indicates a hazardous situation which, if
CAUTION
not avoided, may result in minor or mo-
derate injury.
1.7

Product-specific safety instructions

DANGER!

Electrical hazard!

Contact with live components will cause
electric shock.
►Unplug device before any service and repair works.
►If the mains cable of the unit is damaged, it
must be replaced by the original BWT connec-
tion cable.
NOTE
►The optimum operating pressure of the product
is between 2 and 8 bar.
In the following sections, you will find product-specific safety instructions
whenever you must perform certain safety-relevant actions on the device.
EN
19