Start-Up Backwashing; Repeat Backwashing; Setting Time And Day - BWT Multi C 1000 Einbau- Und Bedienungsanleitung

EN
i.e.
i.e.
Day of the week
I = Monday
2 = Tuesday
3 = Wednesday
...
i.e.
24
StArt
26:45
rEG On
26:45
rEG On
SEt
4 .....08:32
5 .....07:43
5 .....07:43
7.3

Start-up backwashing

● Insert mains plug.
● Water supply must remain closed.
● The display shows StArt and then alternates between the capacity
and day of the week (1-7) / time.
● Allow basic fixing to finish (approx. 40 sec.) The running noise stops.
● An automatic backwashing starts.
● Slowly open the water supply to set the unit under pressure.
The display alternates between:
– remaining backwashing time in minutes (with a flashing symbol)
– rEG On
At the end of the backwashing the flushing water must look clear.
If it does not look clear, repeat the backwashing.
7.4

Repeat backwashing

Press OK about 4 sec. until the backwashing starts.
The display alternates between:
– remaining backwashing time in minutes (with a flashing symbol)
– rEG On
7.5

Setting time and day

Press Browse
Flashing digits can be changed
Changes the numbers
Moves the cursor
Set day of the week
Press Browse
Press OK
The programming is complete.
The unit is ready.