Addition (Plus); Subtraction (Minus) - Parkside PLEM 50 C3 Bedienungs- Und Sicherheitshinweise

Addition (Plus)

1. To add two individual values, take a measurement (length or
area or volume) so that the display is showing a value.
2. Then press the add / subtract button
tion (Plus) function. Now, the plus symbol will be flashing on
the "value-3" row
3. Now take a second measurement (length or area or volume).
The second measured / calculated value will be shown on the
"value-3" row
urement, the added result will be shown on the bottom row
of the display. The first measured / calculated value will be
23
shown on the "value-2" row
Note:
- The addition can be carried out with all units (length, area,
volume). You can also include the measurement results of
functions such as area and volume in the addition.
- Only values of the same units can be added. The first
measured / calculated value sets the unit to be used.
- Addition cannot be used with Pythagoras theorem.
- Result of an addition and the individual values of the addition
are automatically stored in the memory.

Subtraction (Minus)

The subtraction of measurements is carried out in the same way as
the addition. The only difference is that the add / subtract button
has to be pressed again while the plus symbol is flashing
7
on the display to get minus symbol on the display. Rest are same.
24 GB
of the display.
22
of the display. Right after the second meas-
22
20
to start the Addi-
7
of the display.