Measurement Value Functions - Parkside PLEM 50 C3 Bedienungs- Und Sicherheitshinweise

observed to get first measured value on the display. This is common.
Now, each measured value will be shown on the display.
2. Stop the measurement by pressing the continuous measurement
button
. The display now shows the maximum (MAX) and minimum
8
(MIN) values
last measured value.
Note:
- Repeat the step 1 to 2 if needed to do another measurement.
- Distance measurement mode icon
tinuous measurement mode while measurement is on process.
- Addition, subtraction, area measurement and volume measurement
cannot be done on on this mode. So, function selection button
and add / subtract button
15
mode.
- If no button is pressed for 3 minutes, the product will power
off itself.
- Beep button
Measurement. So, activation or deactivation of beep sound is
recommended to do prior to the continuous measurement.

Measurement value functions

To make it easier to process measurement results, the product offers
a number of integrated functions. By pressing the Function selection
button
15
20 GB
or MEAS button
14
of that particular measurement series and the
21
will be inactive while doing Continuous
13
repeatedly, you can activate the following functions
or return / Clear button
16
will be flashing under con-
26
will be inactive at this
7