FLORABEST FHL 900 D4 Originalbetriebsanleitung Seite 9

GB IE
and refrigerators. There is an in-
creased risk of electric shock if your
body is earthed or grounded.
Do not expose power tools to
•
rain or wet conditions. Water
entering a power tool will increase the
risk of electric shock.
Do not abuse the cord. Never
•
use the cord for carrying, pulling
or unplugging the power tool.
Keep cord away from heat, oil,
sharp edges or moving parts.
Damaged or entangled cords increase
the risk of electric shock.
When operating a power tool
•
outdoors, use an extension cord
suitable for outdoor use. Use of a
cord suitable for outdoor use reduces
the risk of electric shock.
If operating a power tool in a
•
damp location is unavoidable,
use a residual current device
(RCD) protected supply. Use of an
RCD reduces the risk of electric shock.
• Where possible, connect the equip-
ment only to a plug socket with a leak-
age-current-operated circuit breaker
(FI switch), with a rated current of not
more than 30 mA.
• If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualified per-
son in order to prevent hazards.
Personal safety
Stay alert, watch what you are
•
doing and use common sense
when operating a power tool.
Do not use a power tool while
you are tired or under the influ-
ence of drugs, alcohol or medi-
cation. A moment of inattention white
operating power tools may result in
serious personal injury.
Use personal protective equip-
•
8
ment. Always wear eye protec-
tion. Protective equipment such as
dust mask, non-skid safety shoes, hard
hat, or hearing protection used for
appropriate conditions will reduce per-
sonal injuries.
• Hold the power tool by insulated grip-
ping surfaces only, because the cutter
blade may contact hidden wiring or its
own cord.
Prevent unintentional starting.
•
Ensure the switch is in the off-
position before connecting to
power source and/or battery
pack, picking up or carrying the
tool. Carrying power tools with your
finger on the switch or energising pow-
er tools that have the switch on invites
accidents.
Remove any adjusting key or
•
wrench before turning the pow-
er tool on. A wrench or a key left at-
tached to a rotating part of the power
tool may result in personal injury.
Do not overreach. Keep proper
•
footing and balance at all times.
This enables better control of the pow-
er tool in unexpected situations.
Dress properly. Do not wear
•
loose clothing or jewellery.
Keep your hair, clothing and
gloves away from moving
parts. Loose clothes, jewellery or long
hair can be caught in moving parts.
Power tool use and care
Do not force the power tool. Use
•
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
Do not use the power tool if the
•
switch does not turn it on and
off. Any power tool that cannot be
controlled with the switch is dangerous
and must be repaired.