Operating The Hedge Trimmer; Swivelling Out The Blade Beam; Attach The Shoulder Strap - FLORABEST FHL 900 D4 Originalbetriebsanleitung

GB IE
Screw the nut onto this from the
threaded rod on the star wheel
(9) and place it sideways in the
holder on the tubular shaft. With
the star wheel, push the threaded
rod (9) through the tubular shaft
and screw the star wheel (9) to-
gether with the nut.
C
3. Assemble the leg protection for
right-handed users in variant a).
For left-handed users, assemble
the leg protection rotated in vari-
ant b) as per the illustration.
Place the leg protection on the
assembly block (21) in position a)
or b) as desired. Push the screws
(20) through the aligning holes
and screw the leg protection onto
the assembly block until it is sit-
ting firmly.
Put the round handle (10) onto
the tubular. Fold the assembly
block of the round handle (10) to
the tubular and screw it with the
star wheel.
The dismantling takes place in reverse
order.
Make sure when mounting the round
handle (10) on the correct position of the
leg protection (18) for right-handed/vari-
ant a) or left-handed/variant b).
See Figure C .
Operating the Hedge
Trimmer
Do not use the equipment without the
hand guard. Wear suitable clothing
and work gloves when working with
the equipment.
Ensure that the equipment is functional
before each use. The On/Off switch
and the safety switch must not be held
closed. They must switch off the motor
10
when on is released. Should a switch
be damaged, stop working with the
equipment. Ensure that the mains volt-
age value matches the label on the
equipment.
Note noise protection and local
specifications. The use of the equip-
ment on certain days (e.g. Sundays
and national holidays), at certain
times of day (lunch times, night time
quiet periods) or in special areas
(e.g. health resorts, clinics etc.) is
restricted or forbidden.
Swivelling Out the Blade
Beam
D
1. Hold the safety blade beam
A
( 1) on the handle to adjust the
blade beam (6).
2. Unscrew the stop lever fixing (4)
from the stop lever (5a).
3. Unlock the stop lever (5a) by
pressing the safety lever (5b).
Press simultaneously on the safe-
ty lever (5b) and stop lever (5a)
to release the safety blade beam
A
fixing ( 1).
4. The safety blade beam (
can now be swivelled out into
the operating position. Use the
stop stages and allow the stop
lever (5a) and safety lever (5b)
to click back in. You can choose
11 stop stages.
5. Screw the stop lever fixing (4)
back into the stop lever (5a).
The angled-in blade shaft is a trans-
port and storage position. For work
with the equipment, the blade shaft
can be angled up to max. 90°.

Attach the shoulder strap

Attach the shoulder strap spring clip
A
1)