TBi Industries TBi PP-TX Betriebsanleitung Seite 52

Operating instructions TBi PP-TX welding torch
Connection plan for TBi PP-TX with potentiometer
Please note that the control cable for the torch's Start/Stop button is also controlled via the external control
cable. A corresponding connection must be made to the connector plug.
Option: Connection of the torch button to Euro connector spring pin
Alternatively to the connection plan illustrated, the Start/Stop signal of the torch button can be
transferred via the pins of the Euro connector as usual. Please proceed as follows:
1. Solder a suitable 2-wire cable with the grey and pink wires of the torch control cable.
2. Open the torch cable support
3. Lead the new 2- wire cable back into the cable support, parallel to the torch control cable.
4. Connect the 2- wire cable to the spring pin connection wires in the cable support. The round,
insulated control cable plug, part. no. 375P000004 is suitable for this.
5. Close the torch cable support and bundle both control cables with cable ties or adhesive tape.
Page 52 / 63
Subject to change without notice.  2020 TBi Industries GmbH
TBi Industries GmbH