Installing And Changing Pressure Roll For Alsi Wire - TBi Industries TBi PP-TX Betriebsanleitung

Operating instructions TBi PP-TX welding torch

3.3.3 Installing and changing pressure roll for AlSi wire

The optional pressure roll for AlSi wires must be installed together with the AlSi feed rolls!
Perform the following steps to change the pressure roll:
1. Open cover (4), loosen tension spring
holder (14) from locking device and flip up
to open.
2. Open pressure roll holder (20) and fold to
the side
3. Install pressure roll for AlSi (part no.
185P101039) according to the supplied
installation instructions:
Page 44 / 63
Subject to change without notice.  2020 TBi Industries GmbH
TBi Industries GmbH