Specifications - TBi Industries TBi PP-TX Betriebsanleitung

Operating instructions TBi PP-TX welding torch

2.2 Specifications

TBi PP-TX
Field of application
Type of guidance
Voltage rating
Cooling method
Capacity
Wire diameter
Gas flow
Potentiometer (optional)
Operating principle for drive
Electrical connection for motor
Wire feed speed
Cable assembly lengths
Limits of the torch cooling
circuit (for water cooled
models only)
Subject to change without notice.  2020 TBi Industries GmbH
TBi MIG/MAG welding torches are intended for use on CE-compliant welding
power sources for metal inert gas welding (MIG), metal active gas welding
(MAG) and metal inert gas soldering processes with commercially-available
round wires. The torches may not be used for other processes.
by hand
The torch is rated for a welding voltage of max. 113 V (peak value).
The control circuit (switch or micro switch) is rated for a voltage
of 50 V, max. 1 A.
Remote control devices with electronic elements may be subject to individual
specifications.
Gas-cooled and water-cooled versions are available. The water-cooled version
includes the additional connections for water inlet and return.
The maximum welding current depends on the torch version used, please refer
to the type plate on the machine side connector of the torch for applicable
data.
The following maximum values apply:

TBi PP-TX 360 (gas-cooled):

TBi PP-TX 411 (water-cooled):

TBi PP-TX 511-CC (water-cooled):
0.8- 1.6 mm
16 l/min
max. 2 units, standard value 10 kΩ, also 1 kΩ, 2.2 kΩ or 4.7 kΩ on request
(select as appropriate for welding machine)
Wire feed with driven roll and a parallel pressure roll
Max. supply voltage 42 V DC, rated power 17,5 W
approx. 2.5 - 18 m/min (depending on electrical connection of the Push-Pull
torch)
4 – 12 m

minimum flow:

min. water pressure:

max. water pressure:

input temperature:

return temperature:

cooling capacity:
Important note!
Return temperatures of more than 60 °C / 140° F may cause
damage or destroy the cable assembly. The cooler must always
be filled with sufficient cooling liquid, please consult the user
manual of the cooling unit. In case of a high thermal load on the
torch, please use a cooler with sufficient capacity.
TBi Industries GmbH
Mix: 260A; CO
60% duty cycle (10 min.)
Mix: 350A; CO
100% duty cycle (10 min.)
Mix: 400A; CO
100% duty cycle (10 min.)
1,2 l/min / 1,1 quarts/min
2,5 bar / 36,3 PSI
3,5 bar / 50,8 PSI
max. 40° C / 104° F
max. 60° C / 140° F
min. 1600 W, depending on the application
310 A,
2:
400A,
2:
: 400A,
2
Page 39 / 63