Conrad Electronic BAR 923 Bedienungsanleitung Seite 50

b) Inserting batteries into the base unit
Insert the batteries first into the remote sensors, if you have not
done it yet. Otherwise, it may happen that the remote sensors will
not be recognized by the base unit correctly.
• Open the battery compartment cover (see figure below, push the clip "1" in
the direction of cover, shown by the arrow, and then remove the cover).
• Insert four (AA) mignon batteries into the battery compartment according to
the correct polarity. The respective figure in the battery compartment will
help you to do this, see also figure below.
• Close the battery compartment. First, insert the positioning pins "2" into the
hole "3" and then close the battery compartment cover.
1
2
When remote sensor batteries are low, a "Battery exhausted"
symbol (" ") appears, while activating the respective channel
("CHANNEL" button).
A "Battery exhausted" symbol also appears when the base unit
batteries are low.
50
3
c) How to use the table stand and wall-mounting
The base unit has a removable table stand.
If you wish to place the base unit on a surface, attach the table stand to the base
unit until it is engaged, as shown in figure below.
To mount the base unit on a wall, hang it on a screw head using the
corresponding mounting hole on the back of the unit.
The remote sensor is equipped with a metal bracket which allows for placement
on a surface. Attach it to the corresponding hole on the back of the unit, see
figure below.
To mount the remote sensor on a wall, hang it on a screw head using the
corresponding mounting hole on the back of the unit.
51