Inhaltsverzeichnis
Werbung
d) Display/Clear maximum/minimum values
The maximum and minimum values for indoor temperature, indoor humidity as
well as values of each three remote sensors will automatically be stored. If you
wish to have them displayed, proceed as follows:
1. If you wish/if required to view the maximum/minimum temperature values,
first select the remote sensor whose values you wish to view by pressing
the "CHANNEL" button.
2. Briefly press the "MEM" button. The maximum values of the remote sensor
selected as well as the indoor temperature and humidity appear on the
display now. In addition, "MAX" will appear on the display.
3. Press the "MEM" button again. The minimum values of the remote sensor
selected as well as the indoor temperature and humidity appear on the
display. "MIN" will appear on the display.
4. By pressing the "MEM" button again, the display returns to the current value
display.
To clear the memory, hold down the "MEM" button for two
seconds. You will hear a signal indicating that the maximum/
minimum temperature readings are cleared now.
If you press the "MEM" button, the readings displayed will
correspond to the current temperature readings until different
values are measured by the unit.
e) Auto scan function for remote sensors
The temperature readings of the remote sensors can automatically be switched
(switches every 3 seconds).
• To activate this function press and hold the "CHANNEL" button for three
seconds, a short signal tone will be heard.
• To deactivate the auto scan function, briefly press the "CHANNEL" button,
a short signal tone will be heard. Now, switch the remote sensors manually
again.
54
A LED
Briefly flashes when the unit transmits data
B Hole for wall-mounting
For wall-mounting of the remote sensor
C Reset button
To return the remote sensor to factory default settings
D Switch for channel selection
To set a channel of the remote sensor (channel 1, 2, 3)
E Battery compartment
Battery compartment for two (AAA) micro batteries
F Battery compartment cover
To close the battery compartment, secured with 3 screws
G Stand
To place the remote sensor on a surface
47
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
