Inhaltsverzeichnis
Werbung
k) Manual time/date setting
If reception problems occur, before making the setting by hand,
switch off the DCF reception first and then simultaneously press
the "MODE" and " " buttons until the DCF icon disappears).
To manually set the time/date, proceed as follows:
• Press and hold the "MODE" button for three seconds. The hour setting on
the bottom display line starts flashing.
• Change the hour format by pressing the " " or " " buttons; you can select
either the common 24-hour format or the 12-hour format.
If you do not want to change a setting, briefly press the "MODE"
button to skip to another one.
If you do not press any button for a minute, the last setting will be
stored and the setting mode will automatically be exited.
• Confirm the entry by briefly pressing the "MODE" button.
• The language indicator is flashing. Pressing the " " or " " buttons will set
the desired weekday display language.
• The following languages are available:
E = English, G = German, F = French, S = Spanish, I = Italian
• Confirm the entry by briefly pressing the "MODE" button.
• The hour indicator is flashing. Press the " " or " " buttons to set the
desired hour.
A quick setting can be done by holding down the " " or " "
buttons for an extended period of time.
• Confirm the entry by briefly pressing the "MODE" button.
• The minute indicator is flashing. Pressing the " " or " " buttons will set the
desired minute.
• Confirm the entry by briefly pressing the "MODE" button.
• The year indicator is flashing. Pressing the " " or " " buttons will set the
desired year.
58
A LC display
Displays the temperature measured by the remote sensor as well as indoor
temperature and time (or date)
B Display window for weather forecast (& Battery exhausted indicator)
• Graphic display of the weather forecast
• Pressure trend indicator
• "Battery exhausted" symbol (if the base unit battery is low)
C Display window for the remote sensor
• Current temperature display of the remote sensor (switchable °C/°F
units)
• Maximum/minimum value display
• Temperature trend indicator
• "Battery exhausted" symbol (if the remote sensor battery is low)
• Channel indicator of the remote sensor (channel 1-3)
D Display window for the base unit
• Current indoor temperature display (switchable °C/°F units)
• Maximum/minimum value display
E Display window for indoor humidity
• Current indoor humidity
• Graphic display of the comfort level indicator
• Maximum and minimum value display
F Time/Date display window
• Display of the current time or date (day, month, year,
weekday) or alarm time
• "AM/PM" symbols for 12-hour display
• Status indicator of the DCF reception
• Bell icon for indicating active alarm
G "MODE" button
To switch between display modes or for entry confirmation
H "CHANNEL" button
To switch between remote sensors
I
"
" button
To activate the alarm time setting
J
"MEM" button
Display/Reset of maximum/minimum temperature readings in storage
43
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
