Inhaltsverzeichnis
Werbung
9. Operation
a) General information
• The "RESET" button on the base unit should only be used in cases where
the unit is malfunctioning (odd icons appear on the LC display). This can
happen, for example, while inserting the batteries.
Carefully press and hold the "RESET" button for one or two seconds, using
a pointed object (for example a ball-point pen).
• Once batteries have been inserted into the remote sensors, they start
transmitting temperature readings at 30-second intervals.
• The base unit will start searching for the remote sensor signals about one
minute after the batteries have been installed.
Upon successful signal reception, corresponding temperature data will be
displayed on the top line. The indoor temperature (sensor is integrated into
the base unit) will be displayed on the second line.
The base unit will automatically update its readings every 30 seconds.
• If no signals are received, blanks ("- - - -") will be displayed and the
reception icon will show "
".
Press the "MEM" and "CHANNEL" buttons at the same time to trigger a
further signal search. This function is very useful to synchronize the
transmission and reception between remote sensors and base unit.
b) Switching between time/date display modes
Briefly pressing the "MODE" button several times will toggle the bottom display
line between the clock, clock with weekday and date.
52
a) Inserting batteries into the remote sensor
• Remove the three screws from the battery compartment cover by using an
appropriate screwdriver.
• Select the desired channel number by using the slide switch "CHANNEL".
Each remote sensor must have different channel numbers!
• Insert two (AAA) micro batteries according to the correct polarity. The
respective figure in the battery compartment will help you to do this, see
also figure below.
• Attach the battery compartment cover to the unit and carefully tighten the
screws.
Please note:
The unit can only recognize a channel number change of the
remote sensor, if you have removed the batteries or pressed the
"RESET" button on the remote sensor.
1
2
3
49
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
