O Perating Conditions; P Rotective Devices - SUHNER ABRASIVE UWG 11-R Originalbetriebsanleitung

Power Output
No-load speed
Max. tool Ø
Grinding spindle thread
Sound pressure level EN 60745
Noise emission level
Vibration EN 60745
Weight w/o cable
Protection class
2.3.2 uwK 11-r
Power voltage
Power Input
Power Output
No-load speed
Max. tool Ø
Grinding spindle thread
Sound pressure level EN 60745
Noise emission level
Vibration EN 60745
Weight w/o cable
Protection class
The specified vibration value was measured with a
standardised test procedure. It can be used to
compare products or to make an initial assess-
ment of the exposure. The vibration emissions may differ
from the specified value, depending on how the power
tool is used. Operating personnel must be protected with
defined safety measures based on the estimated expo-
sure under the actual conditions of use (these must take
into account all phases of the operating cycle, e.g. the
times when the power tool is switched OFF and the times
it is switched ON, but is not under load).
2.4 o
perAting conditions
Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3.
haNDLINg
3.1 p
rotectiVe deVices
For safety reasons, always use the safety
guard provided for the respective wheel!
640W 3.1.1 A
10500min
-1
125mm
M14
93dB(A), K=3dB
104dB(A), K=3dB
6m/s 2 , K=1.5m/s 2
2.1kg
II
230/240V, 50/60Hz
1700W Push and hold the lever. (1). Place the safety guard in the
1040W position indicated (2). Release the lever and turn the safe-
11000min -1 ty guard until the lever engages.
125mm
M14
93dB(A), K=3dB
104dB(A), K=3dB
6m/s , K=1.5m/s
2 2
2.5kg
II
Push the lever and turn the safety guard until the closed
section is facing the operator. Make sure that the guard is
placed securely: The lever must engage and you should
not be able to turn the safety guard.
Use only accessories that are covered by at least 3.4 mm
by the safety guard.
Disassemble in reverse order.
For reasons of safety, attach the cutting guard before per-
forming cutting-off operations.
3.1.2 A
/ o
PERaTIoN
Always work with the additional handle attached! Attach
the additional handle on the left or right of the machine
and secure.
ttAch the sAfety guArd
ttAching the AdditionAl hAndle
23