Configuration / Customer Configuration - Balluff BIS C-6 0 RS 232 Serie Handbuch

C-6_0-007-00_836905_E_0704.p65
27
Menu Allocate
Input/Outputs
(continued)
28
Initialization
28 english
BIS C-6_0
Configuration
Read and transmit tag data without command:
The given number of bytes (Number of bytes from Start address) will be read from a newly
recognized data carrier.
After they are read, the data will be automatically sent to the interface.
Additionally, as termination, a BBC and/or 1 or 2 freely definable terminating characters can
be sent.
data transmission after CT-Present
startaddress:
number of byte:
BCC [ ] yes
1. terminator: [ ] yes
2. terminator: [ ] yes
< Data to BIS > < Store >
Customer Configuration
Please note the settings in the label fields on the inside of the processor cover so that in case
of repair of the processor the settings can be reset in the factory. Note the settings also in the
following fields so that you can set, e.g. other units, to an identical configuration.
Baudrate
Interface
Block size
Protocol
2 2
type
Parameters
On the following page you will find an example which shows how you can print-out after
initializing. Enter the settings in the appropriate fields so that you have them handy and can
reproduce the settings at any time. You can then enter the data in short form into the mask.
(see also page 29).
SHORTFORM OF INITIALIZATION BIS C-600
[ 19200 ] [ 8 ] [ 1 ] [ N ]
[ 4 ] [ 2] [ 2 ] [ 2 ] [ 1 ]
[ 01101100 ]
< B = <– > < ESC = Exit >
data
[ 0000 ] decimal
[ 0000 ] decimal
terminator
value: [ 000 ] dec.
value: [ 000 ] dec.
< ESC = Exit > < F1 = Help >
Data Stop Pa-
bit bit ity
Input
< F1 = Help >
27
english