Configuration - Balluff BIS C-6 0 RS 232 Serie Handbuch

C-6_0-007-00_836905_E_0704.p65
11

Configuration

12
Interface Menu
BIS C-6_0
12 english
BIS C-6_0
Configuration
Before programming, the processor configuration must be carried out, in case the factory
settings will not be used.
Configuration is done using a computer and the Balluff BISC600A.EXE software, and it is
stored in the processor. It may be overwritten at any time. The configuration can be stored in a
file, making it accessible when required.
Important.
Please note the selected settings on the stick-on label supplied (to be pasted on the inside of
the processor cover) as well as on page 28 and 30 in the customer configuration section, so
that in case of repair of the processor the settings can be saved or otherwise can also be used
to set other processor units.
BIS C-6_0
Configuration, Interface
Interface BIS C-600
The first screen shows the parameters baud rate, number of data and stop bits, and parity type
for the serial interface selected. The graphic shows the factory settings. The other settings are
carried out in the corresponding masks which are illustrated in the following pages.
INTERFACE BIS C-600
baudrate
( ) 600 baud
( ) 1200 baud
( ) 2400 baud
( ) 4800 baud
( • ) 9600 baud
( ) 19200 baud
< Next > < Shortform > < ESC = Exit >
If the initializing data are available in short form (e.g. on the processor cover after a replace-
ment of the unit) the data can be entered directly into the "Shortform of initialization
BIS C-600" mask (see also Customer cofiguration on page 28/29).
SHORTFORM OF INITIALIZATION BIS C-600
[ 09600 ] [ 8 ] [ 1 ] [ E ]
[ 1 ] [ 2 ] [ 2 ] [ 1 ] [ 1 ]
[ 00000000 ]
< B = <– > < ESC = Exit >
databit parity
( ) 7 ( ) odd
( • ) 8 ( • ) even
( ) none
stopbit
( • ) 1
( ) 2
< Print . . . . > < F1 = Help >
< F1 = Help >
Please note.
11
english