Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
C-6_0-007-00_836905_E_0704.p65
23
Menu Allocate
Input/Outputs
(BIS C-600 only)
(continued)
24
Menu Allocate
Input/Outputs
(continued)
24
english
BIS C-600
Configuration
Output Data Bits of variable Addresses:
1 data bit of an address or 1 bit each from up to 4 addresses can be output on one of the
4 outputs and then inverted or not inverted.
Output data bits of variable addresses
Address
Bit-Number
[ 9999 ]
[ 1 ]
[ 9999 ]
[ 2 ]
[ 9999 ]
[ 3 ]
[ 9999 ]
[ 4 ]
< Data to BIS >
< Store >
If the parameter "Process outputs with CT-Present" is included in the initialization, then this
function also will be carried out on recognition of a new data carrier (one or more of the
addresses given should be on the first page of the data carrier).
BIS C-6_0
Configuration
Programming a Data Bit on the Data carrier depending on the Input:
On recognition of a new data carrier the state of the digital input will be written as a direct or
inverted bit on the data carrier. The address range is 0...31! Bit nummer of the address is 1...8.
The outputs to be used for the ready and release signals should also be given. If release
output is given as "0" then the release function will not be used. The procedure is described
below.
Program input as data bit to data carrier
address
[ 00 ]
bit number
[ 1 ]
ready output
[ 1 ]
release output
[ 0 ]
< Data to BIS >
< Store >
Procedure without Release Signal
On recognition of a new data carrier the defined bit of the given address will be written, direct
or inverted. After a successful write operation, the given ready output is set until the data
carrier leaves the active read/write range. The input must hold its state until the ready output
is set.
The input state that is to be written as information on the data carrier must be present already
before the presence of the new data carrier is recognized.
Output
Invert
[ 1 ]
[ ] yes
[ 1 ]
[ ] yes
[ 1 ]
[ ] yes
[ 1 ]
[ ] yes
< ESC = Exit >
< F1 = Help >
english
[ ] Input inverse ?
< ESC = Exit >
< F1 = Help >
23
Werbung
Inhaltsverzeichnis
