Other Functions - Wilo Para MAXO Einbau- Und Betriebsanleitung

en Description and function
The pump provides the following information:
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
Behaviour when a cable breaks: If the signal cable is disconnected from the pump, e.g.
due to a cable break, the pump activates an alternative fallback mode, which can be
configured via Modbus.
The pump receives the following parameters by default:
Parameters
Address
Baud rate
Frame parity
Table 5: Parameters
NOTICE
By default, the pump waits for initialisation after being switched on.
To find out more about how to handle the Modbus interface, please contact the Wilo
technical support.
6.3

Other functions

Venting
The pump venting function vents the pump automatically.
The heating system is not vented.
For information on activation, see section "Commissioning".
76
Volume flow (Q)
Delivery head (H)
Power consumption (P)
Current speed (n)
Energy consumption (E)
Current operating mode
Pump status
Error information (see section "Faults, causes and remedies")
Standard value
101
19,200 kbps
8E1
WILO SE 2022-04