Tektronix 2 Serie Schnellstartanleitung Seite 22

Description
6 To power the instrument, connect the supplied power cord to the power connector slot on the side of the instrument. Then connect
the power cord to the appropriate AC mains source and use the power button. Use only the power cord specified for this product and
certified for the country of use.
To completely remove power from the instrument, disconnect the power cord. Use the power cord latch when removing the power
cord from the power connector.
7 The power cord has a high force, latching connector to secure the power cord in place. The latch has two opposite facing arrows on
it. Push the latch in until the connector is fully seated.
Hold onto the power cord latch and move it away from the power connector slot to disconnect the power cord.
8 Use the security lock connector to secure the oscilloscope to a work bench or other location with a standard PC/laptop lock cable.
9 Use the battery interface connector to connect the external battery pack to the instrument. See the instructions that come with the
battery pack for more information.
CAUTION: The battery interface connector is susceptible to Electrostatic Discharge (ESD). Use ESD precautions with
installing or removing the battery pack.
10 Use the VESA mount (100mm x 100mm) screws to mount your instrument to the supplied stand or other compatible VESA
accessories.
MSO24, MSO22 2 Series Mixed Signal Oscilloscopes Quick Start Manual
Getting acquainted with your instrument
22