Assistance And Repairs; Warranty Coverage; Maintenance Table - Stiga MP 900 Li 48 Gebrauchsanweisung

• Only hold the machine using the hand grips and
position the bar in the opposite direction to that
used during operation;
When transporting the machine on a vehicle,
always:
• fasten the machine securely with cables or
chains;
• position it so that it does not cause a hazard to
anyone

11. ASSISTANCE AND REPAIRS

This manual provides
information to run the machine and for correct
basic maintenance operations which can be
performed by the user. Any regulations and
maintenance operations not described herein
must be carried out by your Dealer or Authorised
Service Centre, which have the necessary
knowledge and equipment to ensure that the
work is carried out correctly, maintaining the
correct degree of safety and the original operating
conditions of the machine.
Any operations performed in unauthorised centres
or by unqualified persons will totally invalidate the
Warranty and all obligations and responsibilities
of the Manufacturer.
• Only authorised service centres can carry out
guaranteed repairs and maintenance.
• The authorised service centres only use
genuine spare parts. Genuine spare parts and

13. MAINTENANCE TABLE

Intervention
MACHINE
Check all fasteners
Safety checks/check controls
Check the chain catcher
Check rod fastening
General cleaning and inspection
Cleaning the chain
Check the machine and bar lubrication holes
Check the chain drive sprocket
Chain maintenance
Bar maintenance
Topping up the chain oil level
* Interventions which must be carried out by your dealer or an authorised service centre
all the necessary
EN - 16
accessories have been designed specifically for
machines.
• Non-genuine spare parts and accessories are
not approved. Use of non-genuine spare parts
and accessories cause the warranty to be
invalidated.
• It is advisable to send your machine once a year
to an authorised service centre for servicing,
assistance and safety device inspection.

12. WARRANTY COVERAGE

The warranty covers all material and manufacturing
defects. The user must follow all the instructions
provided in the accompanying documentation.
The warranty does not cover damages caused by:
• Failure to
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of accessories not supplied or approved by
the manufacturer.
The warranty does not cover:
• Normal wear and tear of consumables, such as
cutting means, safety bolts.
• Normal wear and tear.
The purchaser is protected by his or her own
national legislation. The purchaser's rights under
the national laws or his or her own country are
not in any way restricted by this warranty.
Frequency
First time And then after
- Before each use
- Before each use
- Before each use
- Before each use
- After each use
- After each use
- Before each use
- Once a month
-
-
- Before each use
become familiar
Paragraph
every
-
-
with the
7.7
6.2
7.5
4.4
7.4
7.4.2
7.6
8.1 *
8.2
8.3
7.3