Guide Bar Maintenance; Storing; Storing The Machine; Storing The Battery - Stiga MP 900 Li 48 Gebrauchsanweisung

• The cut is not straight.
• Vibrations increase.
ATTENTION
Kickback may occur if the chain is not sufficiently
sharpened
DANGER
It is recommended to have an Authorised centre
sharpen the chain using the right tools to ensure
minimum removal of material and even sharpness
on all the cutting edges.
8.2.1 Replacing the toothed chain
Replace the chain whenever:
• the length of the cutting edges reduces to 5 mm
or less;
• there is too much play between the links and the
rivets.
• the cutting speed is too slow and the repeated
sharpening does not improve the cutting speed.
The chain is worn.
NOTE
After replacing the chain, its tension level must
be checked more frequently due to settling of the
chain.

8.3 GUIDE BAR MAINTENANCE

ATTENTION
Any work on the guide bar requires specific
experience and special tools in order to achieve
top workmanship standards; for safety purposes,
we recommend you contact your dealer to ensure
work is done correctly.
To avoid asymmetrical wear on the bar, make sure
it is turned over periodically.
To keep the bar in perfect working order, proceed
as follows:
1. grease the bearings on the nose sprocket (if
present) with the syringe (not included).
2. clean the bar groove with the scraper (not
included) (Fig. 24.A);
3. clean the lubrication holes (Fig. 24.B);
4. with a flat file, remove burr from the edges and
level off the guides.
8.3.1 Replacing the bar
Replace the bar whenever:
• the groove is not as deep as the height of the
drive links (which must never touch the bottom);
• the inside of the guide is worn enough
to make the chain lean to one side.

9. STORING

DANGER
The safety regulations to follow for putting into
storage are described in paragraph 2.4. Strictly
comply with these instructions to avoid serious
risks or dangers.

9.1 STORING THE MACHINE

When the machine is to be stored away:
1. Remove the battery from its housing and
recharge it;
2. Mount the bar cover.
3. Wait until the motor is sufficiently cold;
4. Clean (par. 7.4).
5. Check there are no loose or damaged
components. If
damaged components and tighten any screws
and loose bolts or contact the authorised
service centre.
6. Store the machine:
– in a dry place
– protected from inclement weather
– in a place where children cannot get to it
– making sure that keys or tools used for
maintenance are removed.

9.2 STORING THE BATTERY

The battery must be kept in a cool, shaded place
without humidity.
NOTE
If unused for any length of time, recharge the
battery every two months to prolong its working
life.

10. HANDLING AND TRANSPORTATION

Whenever the machine is to be handled, raised,
transported or tilted you must:
• Stop the machine;
• Wait until the chain is stationary;
• Remove the battery from its housing and
recharge it;
• Mount the bar cover;
• Wait until the motor is sufficiently cold;
• Wear heavy work gloves;
EN - 15
necessary, replace the