Start-Up; Working - Stiga MP 900 Li 48 Gebrauchsanweisung

6.2.2 Machine operating test
Action
1. Insert the battery
in one of the
compartments
of the battery
backpack
(par. 7.2.3 ).
2. Use the connection
cable to connect
the machine to the
battery backpack
(Fig. 15 ).
3. Select the battery
using the selector
(Fig. 4.B).
1. Operate the throttle
control lever (Fig.
12.A). (without
pressing the throttle
locking lever).
1. Operate throttle
locking lever
(Fig. 12.A) and
throttle control
lever (Fig. 12.B).
1. Release the
throttle control
lever (Fig. 12.A).
DANGER
If any of the results fail to match the instructions
provided in the tables, do not use the machine!
Contact a service centre to have it checked and
repaired if necessary.

6.3 START-UP

6.3.1 Start-up with battery
1. Remove the protection bar cover (Fig. 1.K).
2. Adopt a firm and well-balanced position.
3. Make sure the bar and the chain are not
touching the ground or any other object.
4. Use the connection cable to connect the
machine to the battery backpack (Fig. 15 ).
5. Fit the battery inside its housing correctly (Fig.
4.B).
6. Activate the throttle lock lever (Fig. 12.B) and
the throttle trigger lever. Fig. 12.A).
7. Set the cutting speed
Result
The blade should
not move.
The throttle control
lever remains blocked.
They must be able
to move freely
without forcing. The
blade moves.
The lever should
automatically and
quickly return to
neutral position.
The blade should stop.
Fig. 12.
( D)

6.4 WORKING

Before delimbing for the first time, make sure:
– to have been specifically trained to use this
type of equipment;
– to wear the harness correctly;
– to have carefully read the safety regulations
and user instructions contained in this
manual;
– you practise first on logs on the ground or
attached to trestles, in order to get familiar
with the machine and the most suitable
cutting techniques.
To use the machine proceed as follows:
• always keep the machine connected to the
correctly worn harness when working (see
paragraph 6.1.2).
• The machine must always be firmly held in both
hands .
DANGER
Stop the machine immediately if the chain stops
during sawing.
NOTE
During use, the battery is protected against total
drainage with a protective device that switches off
the machine and stops it from working.
6.4.1 Checks to be conducted
whilst working
6.4.1.a Checking the chain tension
The chain tends to stretch gradually as you work,
so you need to check its tension frequently (par.
6.1.4).
6.4.1.b Checking the oil delivery
ATTENTION
Never use the machine without lubrication!
DANGER
Make sure the bar and the chain are in place when
you check the oil delivery.
Start the motor (par. 6.3) and check if the chain oil
is delivered as shown in (Fig. 16).
EN - 11