Behandlung Element Warten In Sequenz - Kistler maXYmos NC 5847-Serie Betriebsanleitung

Projektierung
6.3.1.6

Behandlung Element Warten in Sequenz

maXYmos NC IN
Bit 9.6 = CONTINUE-FROM-WAIT = 1
maXYmos NC IN
Bit 9.6 = CONTINUE-FROM-WAIT = 0
002-679d-08.19
Start
Warten bearbeiten
Vorbedingung: Sequenz läuft
maXYmos NC OUT gespiegelt
Bit 9.1 = MIRROR-RUN-SEQUENCE = 1
Bit 2.0 ... 2.6 = MP
Bit 12.0 ... 12.1 = MIRROR-CURENT- SEQUENCE = 0 ... 3
maXYmos NC OUT
Bit 13.0 ... 13.4 = LABEL = 0 ... 31
Bit 10.5 = DRIVE-ENABLED = 1
Bit 10.1 = SEQENCE-END = 0
Bit 10.0 = SEQUENCE-STOPPED = 0
Bit 9.6 = WAIT-REQUEST = 0
Warten steht an
Sequenz fortsetzen
Sequenz wird
fortgesetzt
Kommando
beenden
Ende
Relative Fahrt kann nicht mehr fortgesetzt werden!
maXYmos NC OUT
Bit 9.6 = WAIT-REQUEST = 1
maXYmos NC OUT
Bit 9.6 = WAIT-REQUEST = 0
Seite 133