Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.5.5 Swing button
This button is used to set the horizontal and vertical
airflow.
Each time the
change as follows:
Set vertical airflow →
Cancel vertical airflow →
Set horizontal airflow →
Cancel horizontal airflow →
Set simultaneous vertical and horizontal airflow →
Cancel simultaneous vertical and horizontal airflow →
Set horizontal airflow.
m
CAUTION
Moving the horizontal and vertical airflow
direction grilles by hand can damage the air
conditioner.
3.5.6 Selection buttons
In Test Running mode, press to control the internal and
external display error code.
In the other modes you can select the desired
temperature:
Increases the temperature by 1°C at a time.
The maximum temperature is 30°C
Reduces the temperature by 1°C at a time.
The minimum temperature is 17°C
20
button is pressed, the settings
3.5.7
Safety lock
The lock function is activated by simultaneously pressing
the fan speed and swing buttons for one second.
This function is available when the unit is on or off. When
these buttons are pressed once, the locks of the unit and
all of its other buttons are disabled (except for the unlock
button). Please note that the remote control can still be
used when the unit is locked. Press the buttons on the
panel and the padlock icon will flash for 5 seconds at 1HZ.
Press these buttons again and the unit will unlock.
3.5.8 Autotest
This function must be activated when installation has
been completed, before start-up: run an auto-check test
of the main unit functions to check if everything is working
properly.
Press the
and
start the test.
After 30 minutes press the button again to stop and exit
the test.
The combination of buttons is valid in any mode when
the unit is on.
The mode button, the fan speed button and the auxiliary
function button are not valid, and all of the other buttons
are valid (including the key). Press up or down to select
the T1, T2, T2, T3 room display (if applicable), outdoor
display (outdoor temperature), and the protection code,
and show "nA" when there is no fault or protection.
Use
buttons for one second to
Werbung
Inhaltsverzeichnis
