CLIVET STANDING 2 IS3-XY 140M Serie Handbuch Seite 48

Position of the pipe/wire hole on the back
Refrigerant
pipe
Drainage
l
WARNING
The electrical wiring, the drainage pipe
and the refrigerant pipe must come out of
the connection in an appropriate place. All
connections must be connected to each other,
fitted uniformly and aesthetically pleasing.
6 Applying mastic sealant and installing the hole cover
on the wall
– Tidy up the tied pipes.
– Apply the mastic sealant evenly over the gaps
between the pipe and the wall, then firmly press
the mastic.
– Extract the wall hole cover to open it. After firmly
fixing it to the pipe, push it into the hole in the
wall to securely fix it to the wall and complete the
installation.
14
Refrigerant/drainage pipe
hole Ø67
Electrical
wiring
Fig. 8
Fig. 9
2.4.3 Preparation for connection pipes
It is necessary to make a hole in the wall where the
refrigerant piping, drainage pipe and electrical cables
that will connect the indoor unit to the outdoor unit will
pass through.
1 Determine hole position in the wall according to
the position of the outdoor unit. The hole in the wall
should have a minimum diameter of 65 mm and a
slight downward slope to facilitate drainage (see "Fig.
10").
2 Drill the hole in the wall using a 65 mm drill bit. The
hole should have a slight inclination, so that the outer
end is lower than the inner one by about 12 mm. This
will facilitate water drainage.
Inside
3 Insert the protective sleeve into the wall, which will
protect the edges of the hole and improve the seal
after installation.
a
CAUTION DANGER
When drilling holes, pay attention to avoid
electrical wires, hydraulic hoses and other
delicate components.
m
CAUTION
The drain pipe outlet must be at least 5 cm
from the floor. If it touches the ground, the unit
can block and not work properly. If the water is
discharged directly into the sewer system, use
a U- or S-shaped drain pipe to block odours
which would otherwise flow back inside.
Installation
Wall
Outside
Fig. 10