Connecting The Transmitter - PeakTech 3432 Bedienungsanleitung

4. Operation of the fuse finder
The PeakTech 3432 is used to locate fuses. The exact
procedure for carrying out the measurement is explained in the
following sections.

4.1 Connecting the Transmitter

The transmitter is needed when locating the fuse, as the device
sends a signal to the line to be measured. When the unit is
plugged into a socket, LED lights in the lower part of the unit
indicate the wiring status. When the middle and right LEDs light
up, the plug is correctly inserted into the socket and you are
able to carry out the measurement. The figure below (Fig. 1)
shows which states can be assumed and indicated by the
LEDs.
Bild 1: LED Anzeige Transmitter
Note: Always make sure that the transmitter is connected correctly and that the two
"correct wiring" lights are displayed before starting the measurement. If this is not the
case, check the connection of the meter again.
18