Replacement Of The Battery - PeakTech 5125 Bedienungsanleitung

b) If the water contains the impurity, then the meter will show the high conductivity
typically.
c) From the different water´s conductivity value, user can judge the water quality
condition. (Due to drinking mineral water contain the mineral material, when
measure the mineral water if the meter displays the high conductivity value, it is
normal).
5.3. Data Hold
During the measurement, pressing the "Hold Button" (3-4) will freeze the display value, at the
same time the LCD will show the "HOLD" indicator. To release the Data Hold function, just
press the "Hold Button" again, then the "HOLD" indicator will disappear and cancel the Data
Hold function.
6. Measuring Consideration
a) The water´s conductivity value should be less within a reasonable value after the "FILTER"
is installed, otherwise the filter is not under normal condition.
b) The conductivity of the pure water will be low value.
c) If the water´s conductivity is high, then the water quality may have some problem. (When
test "Drinking Mineral Water", the meter may show the high conductivity value, it is
normal).
d) After making the water pure test process, then conductivity value should less.

7. Replacement of the battery

1. When the left corner of LCD display show the indicator "
the battery. However, in-spec measurement may still be made for several hours after low
battery indicator appears before the instrument become inaccurate.
2. Slide the "Battery Cover" (3-6) away from the instrument and remove the battery.
3. Replace with 9 V battery, heavy duty type, or equivalent and restate the cover.
4. Make sure, the battery cover is secured after change the battery.
", it is necessary to replace
-17-