Balancing The Trimmer; Removing And Fitting The Battery; Inserting The Battery - Stihl FSA 90 Gebrauchsanleitung

10 Removing and Fitting the Battery

► Undo the screws (2).
► Move the loop handle (1) to the required posi‐
tion and check that the following conditions
are met:
– If you are using a mowing head: a = no
more than 30 cm
– If you are using a metal cutting attachment:
a = no more than 25 cm
► Tighten down the screws (2) so that the loop
handle (1) cannot be rotated on the shaft.
9.3

Balancing the Trimmer

The cutting attachment should rest lightly on the
ground.
► Switch off the trimmer and push retaining latch
to position .
► Connect the carrying ring (1) to the carabi‐
ner (2).
► Wait for the trimmer to stop swinging.
► Check position of cutting attachment. If it
needs adjustment:
0458-709-9921-C
a
1
2
1
2
3
► Loosen the screw (3).
► Move carrying ring (2) up or down the drive
tube until correct balanced position is reached.
► Tighten down the screw (3) firmly.
10 Removing and Fitting the
Battery
10.1

Inserting the Battery

1
2
► Insert the battery (1) up to the limit stop into
the battery compartment (2).
The battery (1) engages with a click and is
now locked.
10.2 Removing the Battery
► Set the brushcutter on a level surface.
► Keep one hand in front of the battery compart‐
ment so that the battery (2) cannot fall out.
1
► Press both locking levers (1).
The battery (2) is unlocked and can be
removed.
English
2
1
2
39