How To Assemble Safety Seat In The Car Group 0+ (Up To 13 Kg) - Lionelo Bastiaan Bedienungsanleitung

The second level is intended for children whose weight is 15-36kg, while the
third level 9-18kg.
SAFETY SEAT ROTATION
Before rotate the seat, loosen TopTether
To rotate the safety seat, press the rotation button and rotate the safety seat (fig. 14).
CAUTION: Before the travel, make sure the safety seat has been locked and
cannot rotate on its own.
HEADREST HEIGHT
The headrest must be positioned at the height which assures that shoulder belts
are at the height of child's shoulders (fig. 15):
A. TOO LOW
To adjust the headrest height, pull the adjustment handle along with the headrest
(fig. 16).
HOW TO ASSEMBLE SAFETY SEAT IN THE CAR
GROUP 0+ (up to 13 kg)
For this weight group the safety seat is assembled in a rear- facing position, with
horizontal position of the backrest and with the use of car seatbelts or ISOFIX
and TOPTETHER system.
Assembly with 5-point safety seat belts and car belts (fig. 17, 18)
1.
Pull the car belt and carry the hip part through the blue guide under the
reduction pad.
2.
Carry the shoulder part of the car belt through the blue guide in the back
of the safety seat.
3.
Fasten the belt, tighten it and make sure it is not twisted.
If in doubt about this point, please contact the manufacturer.
Assembly with ISOFIX system
Before installing, read the vehicle's instruction manual.
1.
Press ISOFIX button to pull out the arms.Insert the arms into ISOFIX handles
in the car.
EN
B. TOO HIGH
‑ 14 ‑
C. OK