Lionelo Bastiaan Bedienungsanleitung Seite 13

To assemble the belts again, retake the actions above in reversed order. Make sure
the belts have been properly inserted in the buckles and are not twisted (fig. 9).
Safety seat belts tension adjustment
1.
Make sure the safety seat belts fit tight to the child's body and are not twisted.
2.
To tighten the belts, pull the shoulder belts upwards and pull the tension
adjustment belt at the same time (fig. 10).
3.
To loosen the belts and adjust their length, press the button between the
child's legs and pull the shoulder arms. Make sure you pull the belts, not
shoulder pads (fig. 11).
Safety seat belts height adjustment
1.
A suitable belts height assures increased comfort and safety of your child. The
height must be adapted in a way that two fingers fit between the child and belts.
2.
To adjust the height, loosen the belts and remove them from the buckles in
the back of the safety seat.
3.
Take the shoulder belts out through the safety seat holes and insert in holes
at relevant height.
4.
Assemble the belts in buckles again (fig. 12).
REMOVING COVER
1.
Remove 5-point belts of the safety seat.
2.
Remove the cover from the base and backrest.
3.
Set a top position of the headrest.
4.
Remove the cover.
To apply the cover again, retake the aforesaid actions in reversed order.
NOTE: Never use the safety seat without the cover.
SAFETY SEAT INCLINATION
The safety seat may be positioned at three inclination angles and in the lying
position (fig. 13).
To incline the safety seat, grab the handle located between the safety seat and
base, and set in a required position.
To adjust the lying position, press the rotation button, turn the safety seat by
180° and then set the lying position of the backrest.
‑ 13 ‑ EN