How To Assemble Safety Seat In The Car - Lionelo Basti aan One Bedienungsanleitung

HEADREST HEIGHT (fig. 15)
The headrest must be positioned at the height which assures that shoulder
belts are at the height of child's shoulders.
A. TOO LOW
To adjust the headrest height, pull the adjustment handle
along with the headrest. To adjust the headrest to a higher position:
loosen the straps, undo the fastening buckle on the back of the seat
(detail 19 in fig. 3) (fig. 16)
HOW TO ASSEMBLE SAFETY SEAT IN
THE CAR
Group
Position of child safety
seat in the car
How to install in
the car
Seat inclination level
1. Rear-facing position with seat belts (group 0+)
a.
Rotate the seat by 90 degrees. Grab the inclination adjustment lever
and incline the seat as far as you can (fifth level - „half-lying"). Rotate
the seat again so that it is in a rear-facing position.
b.
Position the child safety seat on the car seat in a rear-facing position.
c.
Pull the seat belt and carry the shoulder part at the back of the
child safety seat. The belt must go through the part between the
headrest and backrest (fig. 18).
d.
Carry the hip part of the seat belt through the guide in the child
B. TOO HIGH
Group 0+
(0 – 13 kg)
Rear-facing Rear-facing
position
• Seat belts • ISOFIX
• ISOFIX + TOP
+ TOP TETHER
TETHER
5
Group I
(9 – 18 kg)
Forward-fac-
position ing position
• Seat belts
• Seat belts
and ISOFIX
5 1-4
‑ 15 ‑
C. OK
Group II and III (15
– 36 kg)
Forward-facing
position
• Seat belts
• Seat belts and
ISOFIX
• Seat belts, ISOFIX
and TOP TETHER
1
EN