How To Assemble - Lionelo Oliver Bedienungsanleitung

HOW TO REMOVE COVER
1.
Remove 5-point belts of the child safety seat (see: HOW TO DISASSEMBLE CHILD
SAFETY SEAT BELTS).
2.
Remove the cover from the base, backrest and then headrest by sliding off and detaching
rubber fasteners.
To put the cover back on, take the aforesaid actions in a reversed order.
NOTE: Never use the child safety seat without its cover.

HOW TO ASSEMBLE

With car seat belts
Group I (9 – 18 kg)
The child secured with child safety seat belts.
1.
Place the child safety seat on the car seat.
2.
Pull the car safety seat (fig. 12).
3.
Carry the shoulder part of the belts through the shoulder belt guide (P).
4.
Carry the hip part of the belt through the hip belt guide (M).
5.
Carry the belts under the seat liner and backrest fabric (fig. 13).
6.
Fasten the belts.
7.
Use your knee to press the child safety seat against the car seat. Tighten the car safety
belts up to make sure they hold the child safety seat properly (fig. 14).
8.
Insert the child in the child safety seat and secure with its belts.
When the assembly is over, make sure the belts have been carried through the guides properly
and are tightened correctly. To do so, try to move the child safety seat and check if it is stable.
Group II and III (15 – 36 kg)
The child safety seat belts are disassembled. The child is secured with car safety belts.
1.
Disassemble 5-point child safety seat belts (see: „HOW TO DISASSEMBLE CHILD
SAFETY SEAT BELTS").
2.
Remove the seat liner (J).
3.
Place the child safety seat on the car seat. Place the child in it.
4.
Pull the car safety belt.
5.
Carry the shoulder belts through the guide in the headrest (A).
6.
Carry the hip part of the belt through the guide of the hip belt (M).
7.
Now pull both belts through the second guide of the hip belt (M) and fasten them.
EN ‑ 12 ‑