Transmitter And Receiver Binding; Transmitter; Status Indicators - Reely Sail Force 435 Bedienungsanleitung

11. Transmitter and receiver binding

Important:
• During the binding process, transmitter and receiver should be within 5 m.
• The transmitter is located inside the battery compartment.
The transmitter and receiver are bound at the factory. If you find that your transmitter and receiver are no longer bound
(receiver status indicator: red on), follow these steps:
1. Transmitter: place the sail control stick in the bottom position.
2. Transmtter: switch the power ON.
3. Receiver: switch the power ON.
4. Receiver: carefully remove it and press the BIND button.
- Binding success: receiver status indicator solid green.
- Binding not successful: transmitter status indicator (flashing green). Switch OFF the transmitter and receiver
then repeat steps 1-3.
5. Receiver: Carefully put it back into the hull.
- The antenna and connected cables should not be tangled or obstruct the servo arms.
- The antenna should extend along the inside of the hull towards the bow. Do not bend!

12. Transmitter

a) Status indicators
Colour Status
Red/green Flashing
Green Solid
Green Flashing
Description
Low battery
Receiver and transmitter paired
Receiver and transmitter not paired
29