2.4
Transport
2.5
Installing/dismantling
Installation and operating instructions • Wilo-Atmos GIGA-I/-D/-B • Ed.01/2023-06
tions as well as specifications issued by the local energy supply
companies.
•
Before commencing work, disconnect the product from the
mains and secure it against being switched on again.
•
Give personnel training on how to establish the electrical con-
nection and the methods for switching off the product.
•
Protect the electrical connection with a residual-current device
(RCD).
•
Observe the technical information in these installation and op-
erating instructions as well as on the rating plate.
•
Earth the product.
•
Comply with the manufacturer's specifications when connect-
ing the product to electrical switching systems.
•
Have a defective connection cable replaced immediately by a
qualified electrician.
•
Never remove operating elements.
•
Comply with the specifications on electro-magnetic compatib-
ility when using electronic start-up controllers (e.g. soft starter
or frequency converter). If required, take into account special
measures (shielded cables, filters, etc.).
•
Wear protective equipment:
safety gloves for protection against cuts
–
safety shoes
–
sealed safety goggles
–
safety helmet (when using lifting equipment)
–
•
Only use legally specified and approved lifting gear.
•
Select the lifting gear based on the prevailing conditions
(weather, attachment point, load etc.).
•
Always attach the lifting gear to the designated attachment
points (lifting eyes).
•
Position the lifting equipment in a way that ensures stability
during use.
•
When using lifting equipment, a second person must be
present to coordinate the procedure if required (e.g. if the op-
erator's field of vision is blocked).
•
Persons must not stand underneath suspended loads. Do not
move loads over workplaces where people are present.
•
Wear protective equipment:
Safety shoes
–
Safety gloves for protection against cuts
–
Safety helmet (when using lifting equipment)
–
•
Locally applicable laws and regulations on work safety and ac-
cident prevention must be complied with.
en
43