Cleaning And Servicing; Service Intervals; Gearbox Oil Change; Spare And Wearing Parts - Beissbarth MS 70 Originalbetriebsanleitung

6. Maintenance
6.1 Suggested lubricants
Component Lubricant
Gearbox ESSO Spartan EP460 ISO 460 DIN 51502-
Hydraulic pump ESSO NUTO H 46
Pneumatic sys- ESSO FEBIS K 32
tem (conditio-
ning assembly)
Tab. 1: Lubricants table.
!
The manufacturer is not liable for any damage
caused by use of lubricants different from those
shown in the table.
6.2

Cleaning and servicing

Before any cleaning or maintenance inter-
vention, disconnect the MS 70 by
means of the main switch and disconnect the
network.
To guarantee full efficiency of the MS 70 and
to ensure functioning without anomalies it is essential
to clean the machine regularly and carry out periodical
maintenance.
Maintenance has to be carried out by the operator
in accordance with the manufacturer's prescriptions
shown here below.
6.2.1

Service intervals

Maintenance
Clean the mechanical moving parts, spray
them with nebulized oil or kerosene and lubri-
cate with appropriate grease
Check transmission belt tensioning in order to
avoid its sliding.
Check the hydraulic control unit oil level and
keep it always between minimum and
Check and maintain the grease level on the
self-centering and on the tool holding arm.
Lubricate with grease the sliding rail of the
trolley.
Change the oil in the hydraulic control unit.
Check the gearbox oil level.
Beissbarth GmbH
6.2.2
1. Power off the equipment.
2. Unscrew the cap with measuring rod on the hydrau-
3. Check that the oil level is between MIN and MAX.
Standard
CLP ISO 34-98-CC
6.2.3
ISO 46 DIN 51502-HLP
DIN 51524 PART.2- 1. Put a collecting tank underneath the gearbox.
HLP ISO 67-43-HM
2. Unscrew the oil discharge screw.
ISO VG 32
3. Discharge the gearbox oil and dispose of it (see
4. Screw the oil discharge screw.
5. Top up with new gearbox oil (see lubricant table).
6.3
Denomination
Rotary union
Anti-extrusion ring BR123
O-ring OR 123
Complete electrovalve 24V DC
Belt A33
4 position control lever
2 position switch
Nylon slider
x
x
x
x
x
x
x
Maintenance | MS 70 | 33
Check the hydraulic control unit oil level
lic control unit.

Gearbox oil change

chap. 7.3).

Spare and wearing parts

en
Order code
1 695 300 432
1 695 040 098
1 695 040 093
1 695 042 413
1 695 042 198
1 695 300 414
1 695 040 586
1 695 300 232
|
1 695 400 366 2010-09-29