RUSTA ADVANCED Gebrauchsanweisung Seite 63

Step 7 –Mat Assembly – Insert Cable Wires
LY
A. Before attaching the springs, you first need to insert two cable wires into the underside of the mat. First
connect two sets of cable wires in the sequence shown below (i.e. connect Cable Wire A with Nut Cap (# N)
Cable Wire A (# J), then to Cable Wire with Nut Cap (# K). Tighten Nut Cap with Wrench (# H) as shown be
7A
K
F# I
Before fi tting the springs, you must
fi rst insert two cable wires into the
bottom of the mat. Fit 2 sets. /
B. Insert the two sets of assembled cable wires through the loops sewn to the underside of Trampoline Mat Innan du monterar fjädrarna måste
du först sätta in två kabelvajrar i
as shown in FIGURE 15.
undersidan av mattan. Montera
2 st set. /
Før du monterer fjærene, må du
sette to kabelvaiere på undersiden
av trampolinen. Monter to sett. /
Bevor Sie die Federn anbringen,
müssen Sie zunächst die zwei
Kabeldrähte in der Unterseite des
Trampolins einsetzen. Montage
2er-Set. /
Ennen jousien asennusta sinun
täytyy ensin pujottaa kaksi
kaapelivaijeria maton alapuolelle.
Asenna kaksi sarjaa.
IM_759013120301_Trampoline_Advanced_550x400cm_v3.indd 63
J
N
# 18
Loop
22
TRAMPOLINE MAT ASSEM
FIGURE 15
# 18
Cable Wire
63
2021-01-27 17:49