RUSTA ADVANCED Gebrauchsanweisung Seite 57

trampoline once it is assembled.
Note: All parts with the same number are interchangeable and have no "right" or "left" orientation.
Make sure that you have plenty of space and a clean dry area suitable for the assembly of this trampoline.
ASSEMBLING THE TRAMPOLINE FRAME / MONTERING AV RAMEN / MONTERING AV
IS ESSENTIAL THAT THE INTENDED SITE FOR THIS TRAMPOLINE IS COMPLETELY FLAT AND LE
RAMMEN / MONTAGE DES RAHMENS / RUNGON ASENNUS
If the ground is uneven this could cause movement in the frame and could cause stress on the joined sect
of the frame that could damage the trampoline and/or can cause serious injury.
1
Step 2 – Center Leg Support Assembly
A. Connect Center Leg Base A and B (# 8 and # 9) together. Secure using Arc Washer (# G), Spring Lock
14
Washer (# E), Screw (# F) and Allen Wrench (# I) as shown in FIGURE 1.
Step 2 – Center Leg Support Assembly
A. Connect Center Leg Base A and B (# 8 and # 9) together. Secure using Arc Washer (# G), Spring Lock
Washer (# E), Screw (# F) and Allen Wrench (# I) as shown in FIGURE 1.
2A
B. Connect Vertical Leg Extension (# 7) to the two ends using Arc Washer (# G), Spring Lock Washer (# E),
Screw (# F) and Allen Wrench (# I) as shown in FIGURE 2 (the assembled parts will be hereinafter referred as
"Center Leg Support").
# G # E # F # I
2B
B. Connect Vertical Leg Extension (# 7) to the two ends using Arc Washer (# G), Spring Lock Washer (# E),
Screw (# F) and Allen Wrench (# I) as shown in FIGURE 2 (the assembled parts will be hereinafter referred as
"Center Leg Support").
# G # E # F # I
# 7
C. Repeat in the same manner for the other set & Center Leg Support.
IM_759013120301_Trampoline_Advanced_550x400cm_v3.indd 57
4
15
6
16
13
12
2
11
9
7
3
# 8
# 8
# 8
5
13
14
1
TRAMPOLINE FRAME ASSEMBLY
10
7
8
5
TRAMPOLINE FRAME ASSEMBLY
1
13
7 9
14
10
13
# 9
# 9
# 9
3
2
6
7
13
4
14
15
8
# I
# F
11
# E
16
# G
12
# I
# F
# E
# G
FIGURE 1
x2
FIGURE 1
x2
# 7
FIGURE 2
2021-01-27 17:49
# 7
57