Noise/Vibration Information; Declarations Of Conformity - Protool PDP 18-2 E-1 Originalbetriebsanleitung

or caused by the user or other damage caused
by not following the operating instructions, or any
fault acknowledged at the time of purchase, is
not covered by the warranty.
Complaints will only be acknowledged if the
equipment has not been dismantled before being
sent back to the suppliers or to an authorised
PROTOOL customer support workshop. Store
the operating instructions, safety notes, spare
parts list and proof of purchase in a safe place.
In addition, the manufacturer's current warranty
conditions apply.
Note
We reserve the right to make changes to the
technical data contained in this information as
a result of ongoing research and development
work.

Noise/vibration information

Levels determined in accordance with EN 60 745
are typically:
PDP 18-2 E-1:
Drilling
Sound pressure level
Noise level
Uncertainty
Percussion drilling
Sound pressure level
Noise level
Uncertainty
CAUTION
Operating noise
Damage to hearing
► Use ear protection!
Vibration emission value a
three directions) and uncertainty K measured in
accordance with EN 60 745:
Drilling
Percussion drilling
Uncertainty
The emission values specified (vibration, noise)
were measured in accordance with the test
conditions stipulated in EN 60 745 and are
intended for machine comparisons. They are
also used for making preliminary estimates
regarding vibration and noise loads during
operation.
14
L = 78 dB (A)
PA
L = 89 dB (A)
WA
K = 3 dB (A)
L = 99 dB (A)
PA
L = 110 dB (A)
WA
K = 3 dB (A)
(vector sum for
h
a = 0.8 m/s
2
h
a = 14.8 m/s
2
h
K = 1.5 m/s
2
The emission values specified refer to the
main applications for which the power tool is
used. If the electric power tool is used for other
applications, with other tools or is not maintained
sufficiently prior to operation, however, the
vibration and noise load may be higher when the
tool is used.
Take into account any machine idling times
and downtimes to estimate these values more
accurately for a specified time period. This may
significantly reduce the load during the machine
operating period.

Declarations of Conformity

Impact Drill
PDP 18-2 E-1
We declare under our sole responsibility that
this product is in conformity with the following
standards or standardization documents:
EN 55 014‑1, EN 55 014‑2, EN 50 366,
EN 60 745‑1, EN 61 000‑3‑2, EN 61 000‑3‑3,
EN 60 745‑2‑1 according to the provisions of the
regulations 2004/108/EC and 2006/42/EC.
All the procedures were applied as validly
amended at the time of the issue of this
declaration, without quoting these.
Technical documentation is kept at the
manufacturer.
10
Stanislav Jakeš
Research and development
Protool GmbH
Wertstr. 20
D‑73240 Wendlingen
30. 4. 2010
Serial no.
625860