Environmental Protection; Maintenance; Noise/Vibration Information; Declaration Of Conformity - Protool DRP13-2EQ Bedienungsanleitung

Environmental Protection

Do not open worn out machines and return to the col-
lection facilities provided for recycling.

Maintenance

Periodically clean the ventilation slots (5) on the motor
housing.
After an operating period of approx. 200 hours, the fol-
lowing maintenance work must be performed:
- Check the motor brushes and replace if necessary.
Clean the motor housing.
- Renew the grease filling of the gearbox.
When the carbon brushes are worn out, the machine
switches itself off. The machine must then be sent to
customer service for maintenance (see enclosed sheet).
To verify that the double insulation is intact, the
machine must be subjected to a safety test after-
wards. Therefore, these maintenance tasks are
to be performed only by a professional electro-
workshop.
Service
See enclosed sheet.
Guarantee
Our equipment is under warranty for at least 12 months
with regard to material or production faults in accord-
ance with national legislation. In the EU countries, the
warranty period for exclusively private use is 24
months (an invoice or delivery note is required as proof
of purchase).
Damage resulting from, in particular, normal wear and
tear, overloading, improper handling, or caused by the
user or other damage caused by not following the ope-
rating instructions, or any fault acknowledged at the
time of purchase, is not covered by the warranty.
Complaints will only be acknowledged if the equip-
ment has not been dismantled before being sent back to
the suppliers or to an authorised PROTOOL customer
support workshop. Store the operating instructions,
safety notes, spare parts list and proof of purchase in a
safe place. In addition, the manufacturer's current war-
ranty conditions apply.
Note
We reserve the right to make changes to the technical
data contained in this information as a result of ongo-
ing research and development work.
12

Noise/vibration information

Measured values determined according to EN 50 144.
DRP 13-2EQ, DRP 13-2EAQ:
Typically the A-weighted noise levels of the tool are:
Sound pressure level: 83 dB (A). Sound power level:
85 dB (A). Wear ear protection!
The typical hand-arm vibration is below 2.5 m/s
PDP 20-2EQ, PDP 20-2EAQ:
Typically the A-weighted noise levels of the product
are: sound pressure level: 92 dB (A); sound power
level: 105 dB (A). Wear ear protection!
The typical weighted acceleration is 9.7 m/s

Declaration of Conformity

We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents: EN 50 144-2-1,
EN 55 014-1, EN 55 014-2, EN 61 000-3-2,
EN 61 000-3-3 according to the provision of the regu-
lations 2004/108 /EC, 98/37/EC.
Manfred Kirchner
Subject to change
2
.
2
.