Starting The Dishwashing Programme; Unloading The Dishwasher - hanseatic HG6085C14T7635EI Gebrauchsanleitung

Starting the dishwashing
programme
(6)
4. Start the programme with the
ton (11). If you have
– not set up a start delay, the programme
cycle will begin after a few seconds.
– set up a delayed start, the display will
initially still show the start-delay du-
ration (6); the dots between
number of hours will flash. After the start
delay runs out, the programme will start.
During the programme the display will
show the time remaining (6); the dots be-
tween hour and minute numbers will flash.
At the end of the programme cycle, an
acoustic signal will sound 8 times and the
end
display will show .
5. Switch the dishwasher off using the
button (18).
6. Turn the tap off.
7. Wait a little while before unloading the
dishwasher.

Unloading the dishwasher

CAUTION!
Risk of scalding!
If you open the appliance door, hot
steam will come out.
Maintain a suffi cient distance from
■
the appliance door and do not hold
(11)
your head or upper body directly
above the open appliance door.
but-
Make sure that children do not open
■
the appliance door if the programme
has only fi nished a short time ago.
Only open the appliance door slight-
■
ly to allow the steam to escape more
H
and the
easily.
Allow the dishes to cool before un-
■
loading the dishwasher.
Tripping hazard!
An open appliance door can quickly be-
come a tripping hazard.
Close the appliance door after every
■
use.
Only leave the appliance door slightly
■
open to cool down.
NOTICE
Risk of damage!
Make sure that children and pets
■
do not stand on the open appliance
door.
Once the programme has come to an end
and the dishes have cooled, you can remove
them.
Page EN-23
Programme table