Herunterladen Inhalt Inhalt Diese Seite drucken

Starting The Dishwashing Programme; Unloading The Dishwasher - hanseatic HG6085C14T7635EI Gebrauchsanleitung

Standgeschirrspüler
Vorschau ausblenden Andere Handbücher für HG6085C14T7635EI:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Starting the dishwashing
programme
(6)
1. Start the programme with the
ton (11).
If you have not set up a delayed start, the
programme cycle will begin after a few
seconds.
If you have set up a delayed start, the dis-
play (10) will initially still show the delayed
start duration (6); the dots between
the number of hours will flash. After the
delayed start duration runs out, the pro-
gramme will start.
During the programme cycle the display
shows the remaining time; the dots be-
tween the hour and minute digits flash.
At the end of the programme cycle, an
acoustic signal will sound 8 times and the
display will show
END
2. Switch the dishwasher off with the
ton (18).
3. Turn the tap off.
4. Wait a little while before unloading the
dishwasher.

Unloading the dishwasher

CAUTION
Risk of scalding!
If you open the appliance door, hot
steam will come out.
■ Maintain a suffi cient distance from
the door and do not hold your head
or upper body directly above the
open door.
(11)
but-
and
H
.
but-
Dishwasher operation
■ Make sure that children do not open
the appliance door if the programme
has only fi nished a short time ago.
■ Only open the appliance door slight-
ly to allow the steam to escape more
easily.
■ Allow the dishes to cool before un-
loading the dishwasher.
Risk of injury!
People may trip over the open appli-
ance door.
■ Note that the door should not be left
in the open position since this can
present a tripping hazard.
■ Close the appliance door after every
use.
■ Only leave the appliance door slightly
open to cool down.
NOTICE
Risk of damage to property!
Improper handling of the appliance
may damage it.
■ Make sure that children and pets
do not stand on the open appliance
door.
Once the programme has come to an end
and the dishes have cooled, you can remove
them.
1. When unloading the dishwasher, start
with the lower rack and then unload the
upper rack. This will prevent water drip-
ping onto the lower layer of dishes from
the top layer of dishes.
2. Leave the appliance door open slightly so
that the inside of the dishwasher can cool
off and dry.
If no further settings are made, the appliance
will automatically switch off/enter standby
mode after 15 minutes.
Page EN-23

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

16760133

Inhaltsverzeichnis