hanseatic HG6085C14T7635EI Gebrauchsanleitung Seite 48

Page EN-8 Safety
The surfaces can be damaged by un-
suitable cleaning agents.
Do not use harsh, aggressive, sol-
■
vent-based or abrasive cleaners.
The appliance is designed for a wa-
ter pressure of 0.4 to 10 bar (0.04 to
1.00 MPa).
If the water pressure is higher than
■
this, install a pressure reducer. If in
doubt, enquire about the water pres-
sure with the water supply company.
Never connect the appliance to the
■
water tap or the mixing arm of a wa-
ter heater (continuous fl ow heater,
pressure-free boiler etc.).
Ensure that the inlet hose is not
■
kinked and is carefully connected.
Do not cut through the inlet hose.
■
It contains electrical components. If
the inlet hose is damaged, have it re-
paired by a specialist.
Do not use old or previously installed
■
inlet or outlet hoses. Only use the sup-
plied hoses.
The outlet hose must be of a mini-
■
mum diameter of 40 mm so that the
water can be pumped away unhin-
dered.
Do not attach the outlet hose your-
■
self, have it installed by a special-
ist plumber. Have the outlet hose
checked regularly for damage or
kinks.
Risk of damage!
Improper handling of the appliance
may cause damage to furniture and
nearby appliances.
Never leave the appliance unsuper-
■
vised for an extended period when
the tap is on.
During storms or when going on holi-
■
day, always withdraw the mains plug
from the socket and close the water
tap.
If there is a risk of frost, loosen the
■
inlet hose and allow the water to run
off.
If you install a microwave over the
■
dishwasher, the dishwasher can be
damaged.
Risks for floor-standing
appliances
CAUTION!
Danger of tipping!
The appliance can tip over.
Do not overload the baskets.
■
NOTICE
Possible damage to property!
Improper handling of the appliance
may result in damage to the appliance
itself.
Do not place the appliance directly
■
next to a non-kitchen, heat-radiating
appliance. The sometimes high radi-
ation temperatures can damage the
dishwasher.