Page EN-24
Dishwasher operation
– To deactivate the option, press the
button again. The indicator will disap-
pear from the display.
Delayed start
(2)
The wash cycle normally starts as soon as
you press the "Start/Pause"
If you want the cycle to begin later, you can
specify this. The start time can be delayed
between 1 and 24 hours.
• Press the
button (2) as many times as
necessary for the display (8) to show the
delay required (
,
H: 0 0
Starting the dishwashing
programme
(1)
(8)
(16)
(8)
button (6).
to
).
H: 0 1
H: 2 4
(6)
1. Start the programme with the
ton (6).
If you
– have not set up a start delay, the pro-
gramme cycle will begin after a few
seconds.
– have set up a delayed start, the dis-
play will initially still show the start-de-
lay duration (8); the dots between
and the number of hours will flash.
After the delayed start duration runs
out, the programme will start.
During the programme the display will
show the time remaining (16) ; the dots
between hour and minute numbers will
flash.
At the end of the programme cycle, an
acoustic signal will sound 8 times and the
display will show
End
2. Switch the dishwasher off with the
ton (1).
3. Turn the tap off.
4. Wait a little while before unloading the
dishwasher.
If no further settings are made, the appliance
will automatically switch off/enter standby
mode after 15 minutes.
Adding dishes
CAUTION
Risk of scalding!
Hot steam emitted when opening the
appliance door can cause scalding.
■ Maintain a sufficient distance from
the appliance door, and do not hold
your head or upper body directly
above the open appliance door.
■ Keep children and pets away from
the appliance when opening the ap-
pliance door.
■ Make sure that children do not open
the appliance door during operation.
but-
H
.
but-