Turning The Motor Plug - SCHUNK LDH Serie Montage- Und Betriebsanleitung

7.3 Turning the motor plug

Removing the motor
plug
Installing the motor
plug
Turning the motor plug
1 Motor plug
Turning the motor plug
1. Remove the motor housing.
Uninstalling the motor housing
2. Unscrew the 2 screws (1).
3. Remove the cable cover (2).
4. Unscrew the 4 screws (3).
5. Carefully pull out the power connector (4) by about 2 mm.
1. Carefully press the power connector (4) into the notch.
2. Screw in the 4 screws (3).
3. Lay the cable parallel into the slot.
4. Fit the cable cover (2).
5. Screw in the 2 screws (1).
6. Install the motor
07.00 | LDH and LDK | Assembly and Operating Manual | en | GAS360923
Maintenance and repair work
[ 122]
}
housing.Installing the motor housing [ } 122]
123