Uninstalling The Motor Housing; Installing The Motor Housing - SCHUNK LDH Serie Montage- Und Betriebsanleitung

Maintenance and repair work

7.2.1 Uninstalling the motor housing

7.2.2 Installing the motor housing

122 07.00 | LDH and LDK | Assembly and Operating Manual | en | GAS360923
changing the motor housing
1. Disassemble the protective conductor and motor cable.
2. Remove the screws (1).
3. Using lifting screws M6x35 ISO4762 (2), lift the motor housing
(3) to bridge the magnetic force.
4. Completely remove the motor housing (3).
1. Fit the lifting screws (2). (Let them protrude 5 mm)
2. Place the motor housing (3) on the guide rail.
3. Slowly unscrew the lifting screws (2) one by one and set the
motor housing onto the guided slide (6).
4. Fit the 4 screws (1).
5. Connect the protective conductor.
6. Connect the motor cable.