Battery Charge Level Indicator; Checking The Chain Brake; Checking The Oil Automatic System; Changing The Saw Bar - Parkside PKSA 20-Li B2 Originalbetriebsanleitung

GB IE
Battery charge level
indicator
The battery's charge level is indicated by
the charge state indicator.
The LEDs indicate the battery's charge
level, when the device is in operation.
To do this, press the softkey of the charge
level indicator.
3 LEDs illuminated (red, orange and green):
Battery charged
2 LEDs illuminated (red and orange):
Battery partially charged
1 LED illuminated (red):
Battery needs to be charged
Checking the chain
brake
The motor cannot be turned on if
the chain brake has engaged. Do
not employ the chain brake in order
to start the chainsaw or to switch it
off.
1. Place the chainsaw onto a solid, flat
surface. It must not contact any objects.
2. Ensure that the chain brake has been
released, that is, that the chain brake
lever (6) is pulled up against the front
grip (5).
3. Hold the chainsaw firmly with both
hands, with the right hand on the rear
handle ( 1) and the left hand on the
front handle (
must close securely over the handles.
4. Turn on the chainsaw.
5. Activate the chain braking lever (6),
with running motor, with the left hand.
6. Once the chain brake is working prop-
46
5). Thumb and finger
erly, release the on/off switch (2) and
the chain brake.
If the chain brake does not
function correctly, you must
not use the chainsaw. A slack
saw chain leads to danger of
injury. Return the chainsaw
to our Service-Center for re-
pair.
Checking the oil automatic
system
Check the oil level and the automatic oil
system before commencement of work.
• Switch on the chainsaw and hold it
above a bright background. The saw
must not touch the ground.
If an oil trace can be seen, the chain-
saw is working trouble-free.
If no oil trace can be seen clean the
oil passages or turn the chainsaw
to our Service-Center for repair.
Clean the oil passages of the chain
bar (24), in order to guarantee a
trouble-free, automatic oiling of the
saw chain during operation.

Changing the saw bar

1. Place the battery (
device (see "Inserting/removing the
rechargeable battery").
2. Lay the saw on a flat surface.
3. Turn the fastening bolt (10) and the
screw for the chain quick-tensioning
system (11) in counter-clockwise
direction in order to loosen the chain
tension and to remove the sprocket
chain wheel cover (12).
16) into the