Balluff BOS R254K-UUI-RS10-S4 Bedienungsanleitung Seite 162

BOS R254K-UUI-RS10-S4
Photoelectric Sensors
6
System Functions (continued)
Namur Standard
LED 1 (operating status and communication)
Name
Failure
Communication
Ready Diagnosis On
Ready Diagnosis Off
Tab. 6-20: LED meaning and configuration – Namur default, LED 1
LED 2 (Indication/Warning/Teach/Device Discovery)
Name
Device Discovery
Short Circuit Pin 2 / Pin 4
Teach-in No Object
Teach-in
Maintenance Required
Functional Check
Overload
Bad Signal Quality
Out of Specification
Tab. 6-21: LED meaning and configuration – Namur default, LED 2
6.6.2 ISDU
Name
LED Standard Selection
Tab. 6-22: LED meaning and configuration – ISDU
76 english
Signal
Static red
Green alternating with LED
off at ratio of 10:1, 1 s
period
Static green
Static white
Signal
Blue, flashing, 3 Hz
Red, flashing, 3 Hz
Red, flashing, 1 Hz
Static red
Blue, static
Orange, static
Orange, flashing, 3 Hz
Orange, flashing, 1 Hz
Yellow, flashing, 3 Hz
Index Subindex
0x00FD (253) 0
Meaning
General error
IO-Link communication is active. The device is ready.
The device is ready. Diagnosis functions are on.
The device is ready. Diagnosis functions are switched off.
Meaning
The Device Discovery can be activated via a system
command to find the device again.
Short circuit at pin 2 or pin 4
The sensor is in Teach-In mode and no object is visible.
Teaching is not possible.
The device is currently in teach-in mode
Maintenance must be performed.
The device is currently being parameterized/adjusted.
Measurement is not currently possible.
Overload on pin 2 / pin 4 has been detected.
Poor signal quality, the signal quality is below the
configured warning threshold.
The device is operated outside of specifications. A
reliable measurement signal can no longer be ensured.
Access Length Data Type
R/W 1 byte UINT8(ENUM)
Data Storage Default
Yes 0